Automated house 2.0 – #17 Ubiquiti Networking part 2 – All Our UniFi Hardware has Arrived!


In the very first part of our house networking series I looked at the reasons why I decided to go with Ubiquiti for the LAN in the new house. The next step was to figure out precisely what I’d requirement to roll out this top-of-the-line house network.

Right now the area where our rack will ultimately be installed still looks quite rough. however ideally over the next few months things will get a great deal more fascinating with this area on the garage wall.

Planner

Feeding our details into the UniFi Network Planner the suggestion was for 5 gain access to points around our new build.

But with its somewhat unusual design (2 buildings side by side) as well as great deals of WiFi killing foil backed insulation, as well as lots of steel too, I decided to get in touch with Ubiquiti about our job as well as run it by them.

After some discussion about our all-block construction, floor area as well as demands for our network, I’m incredibly grateful to have got this hardware direct from Ubiquiti to power the Automated house 2.0 network!

Switch

Let’s begin with the switch, as quite much whatever else is going to link to it. This is the 48 port 500 watt PoE (Power over Ethernet) design which will power all of our WAPs (Wireless gain access to Points) directly in addition to our security cameras too. It’s a full handled rack mount, gigabit Ethernet switch as well as all 48 ports support 802.3at, 802.3af & 24V Passive PoE. In addition there are 2 SFP ports as well as 2 SFP+ ports for 10 gb links to other devices.

As a guide, wireless gain access to points as well as cameras generally utilize around 6 Watts, so with 7 APs, perhaps as much as a lots cameras as well as the 13 Watt Cloud key Controller, we’ll have a needed PoE budget plan of around 130 Watts – so well within the abilities of this switch (maximum PoE+ output for any type of private port is 34 Watts).

If you don’t requirement so many ports then Ubiquiti’s PoE switch varieties starts with this bit 8 port 60 Watt version. On the other hand if you need a layer 3 switch inspect out the new pro designs in the Gen2 range.

Model: US-48-500WLocation: RackAvailable from Amazon

#
Preview
Product
Rating
Price

1

Ubiquiti US-48-500W 500 W 48 Port UniFi PoE switch

121 Reviews

£774.42

buy on Amazon

Security Gateway

The UniFi security Gateway pro is a rack mountable router that will handle our connection to the Web as well as provide our firewall. It handles DHCP, DPI (Deep packet Inspection) to see what sites as well as services the gadgets on our LAN are using. In addition it features IDS (Intrusion Detection System) alerts for malware as well as vulnerabilities as well as IPS (Intrusion Prevention System) which will really block these threats. It’s likewise a VPN server enabling us to join our house LAN with a secure as well as encrypt personal connection when away from home.

With 2 WAN ports there’s range to add a 4G cellular connection for failover too, although that is something I requirement to look into in more detail in the future (the UniFi LTE looks perfect however is not offered in the UK yet). The pro has quicker with put than the basic USG, which will be needed for the FTTP connection that should ended up being offered to us in the not as well far-off future.

Model: USG-PRO-4Location: RackAvailable from Amazon

#
Preview
Product
Rating
Price

1

Ubiquiti USG-PRO-4 UniFi security business Gateway Router with Gigabit Ethernet247 Reviews

£293.00

buy on Amazon

Cloud key & CCTV Recorder

You do not requirement have a ‘Controller’ running for UniFi WiFi to work. However, it is a demand for setting up the system, in addition to providing all the awesome tracking as well as manage features. So if you are going to the difficulty of installing a appropriate UniFi configuration then you should definitely plan to run one.

There are a couple of methods to provide the Controller, which is accessed with a web browser interface. If you have an always on PC, Mac, or Raspberry Pi already running 24/7 then you can download as well as set up a software application controller. You can even run the controller on your NAS as well as there are cloud services that will hold this for you as well if you prefer.

But a nice choice is Ubiquiti’s own Cloud key range. These are bit computers that run stand alone as well as we’ve got the Gen2 plus Cloud Key. This system likewise provides the extra UniFi protect software application plus a built-in 1TB difficult drive for security camera duties (the 2.5″ disk is individual replaceable as much as 5TB). There’s likewise a rack install accessory for the Cloud key Gen2 plus which I mean to buy so this system can be integrated into our rack configuration too.

Model: UCK-G2-PLUSLocation: RackAvailable from Amazon

#
Preview
Product
Rating
Price

1

Ubiquiti Networks UniFi Cloud key Gen2 plus (UCK-G2-PLUS), single

1,676 Reviews

£177.45

buy on Amazon

Wireless gain access to Points

Most garden-variety house WiFi systems available just offer a single type of gain access to point. however with Ubiquiti there are many SKUs to select from, depending upon the task in hand as well as where the system is going to be located.

We’re utilizing great deals of 3rd Gen UniFi gain access to points including a couple of the ‘flying saucers’ that Ubiquiti are famous for. The disk shaped nanoHD system is an indoor AP that’s powered by 802.3af PoE as well as supports 4×4 MU-MIMO.

That provides a theoretical aggregated maximum throughput of 1,733 Mbps on 5 GHz as well as 300 Mpbs on 2.4 GHz. In practical terms these units are of program restricted by the 1,000 Mbps of our Ethernet port on the wired side. They support 200+ concurrent individuals as well as are especially well fit to the contemporary 5 GHz gadgets we’ll be utilizing in the house.

Each wired system can likewise provide a wireless link to one more gain access to point for growth that doesn’t requirement more network cables. We won’t requirement this ‘Mesh’ configuration though as each WAP will be fed from its own CAT6a cable run back to the switch. The UniFi AP flex HD is one more WAP type factor just shown up in the UK that’s worth inspecting out too.

Model: UAP-nanoHDLocations: 2 units, 1 x kitchen area Island, 1 x Living area TV UnitAvailable from Amazon

#
Preview
Product
Rating
Price

1

Ubiquiti UniFi nanoHD (UAP-NanoHD) [WLAN AC, 4×4 MU-MIMO, 1733 Mbit/s + 300 Mbit/s]273 Reviews

£142.03

buy on Amazon

I’ve got 4 of the latest in-wall HD gain access to points too. These are basically the exact same radios as the nanoHD above however in a different indoor type factor, with some awesome extras.

They are perfect for our bedrooms as they provide a truly neat WAP which attaches to the wall (so no requirement for anything on the ceilings), plus they have a bit built-in switch to provide Ethernet too. So this single neat system provides WiFi to the space – 3 routine Gigabit Ethernet sockets for PCs etc, as well as a 4th PoE Gigabit port for something like a security camera or a VoIP phone (802.3af PoE as well as 802.3at PoE+ input supported).

Model: UAP-IW-HDLocation: 4 units – 1 x Master Bed, 1 x Snug, 1 x bedroom 2, 1 x bedroom 3Available from Amazon

#
Preview
Product
Rating
Price

1

Ubiquiti UniFi HD In-Wall 802.11ac Wave 2 Wi-Fi gain access to point 4 Port Ethernet Switch, UAP-IW-HD

70 Reviews

£146.93

buy on Amazon

With a vehicle that gets regular over-the-air software application updates, an gain access to point in the garage is great method too. For this I’ve selected the indoor / outside rated AC fit together that can be powered from 24V Passive PoE or 802.3af. It’s a 2×2 MIMO system with support for as much as 300 Mbps on 2.4 GHz as well as 867 Mbps on 5 GHz. lots of performance for the vehicle and, like with most UniFi WAPs, it has the capability to broaden the network outside via a fit together configuration in the future.

Model: UAP-AC-MLocation: GarageAvailable from Amazon

#
Preview
Product
Rating
Price

1

Ubiquiti UniFi AC outside fit together

1,551 Reviews

£131.00

buy on Amazon

Cameras

Part of the attraction of the UniFi system is the depth of its product variety and, like with the Loxone configuration we’ve selected for our wise house system, their capability to all work together seamlessly.

That includes the security cameras as well as we’re lucky to have got one of these variety topping G4 Pro’s to install. This is an indoor / outside (IP67) 4K camera (3840 x 2160) with a powered 3x optical zoom (4.24 mm – 12.66 mm, ƒ/1.53 – ƒ/3.3) which enables for adjustable framing.

There’s an on-board microphone, IR for night time illumination

Leave a Reply

Your email address will not be published. Required fields are marked *